Category: Uncategorised

The LimeRFE crowdfunding campaign has a new, lower-cost option: the same programmable software-defined front-end board but without the components needed to operate in cellular bands, as an alternative for radio amateurs. “We’ve had some enquiries as to whether it would be possible to make a reduced cost version of LimeRFE…

We are delighted once again to be participating in Google Summer of Code as a mentoring organisation with the Free and Open Source SIlicon Foundation. Stefan Wallentowitz, FOSSi Foundation Director, notes “Google Summer of Code is an excellent program for students to get a stipend by Google to work on…

The fourth instalment of the Wireless Masterclass series has been published to YouTube and this takes a look at advance digital radio, with Dr Danny Webster exploring topics including, detecting and reducing data loss, spread spectrum, OFDM and MIMO. If you missed the previous episodes these can be found at:…

Welcome to the ninth episode in the LimeSDR Made Simple series. Since the first we’ve been gradually adding more tools to the SDR toolbox and if you have followed the series along, by now the operation of the LimeSDR should be well and truly demystified. Last time we looked…

The third instalment of the Wireless Masterclass series has now been published to YouTube and this takes a look at the real radio link, with Dr Danny Webster covering topics including the noise floor and line-of-sight link budgets, bad neighbours, and receiver and propagation effects on received signals. This is…

The second video in the Wireless Masterclass series has been published to YouTube and in this Dr Danny Webster introduces the LimeSDR and takes a look at the LMS7002 FPRF architecture, covering the analogue and digital halves of the chip for both transmit and receive chains. The highly integrated…

Receiving and transmitting ASK/OOK signals in GNU Radio Welcome to the seventh instalment of LimeSDR Made Simple. In this post we pick up where we left off in the previous, trying to mimic the simplest of radio devices. In the last instalment we got to a point where we could…

Back in March we hosted a 1-day LimeSDR workshop in London, in partnership with the BCS Open Source Specialist Group and Open Source Hardware User Group. For this Principle RF Design Engineer at Lime Micro, Dr Danny Webster, put together a series of presentations that provide an introduction…

Receiving ASK/OOK signals in Pothos and GNU Radio. Welcome to the sixth instalment of LimeSDR Made Simple. Last time we looked at transmitting and receiving ASK (amplitude shift keying) signals in Octave. However, we mostly glossed over the modulation and techniques involved. In the next post(s) we will look…

This is the fifth instalment of LimeSDR Made Simple and in the last we explored the software side of the software-defined radio, using the relatively simple to use dataflow programming environment, Pothos. Quite a break from the previous articles where we went into detail of the input stages of the…

It’s time again for another bite sized chunk of LimeSDR. This is the fourth post in the series and while this will be our second practical exercise, it does build upon the whole series and so if you have not read the first three articles, you are advised to take…

This is the third in a series of posts that aims to make the LimeSDR platform a little more approachable. Again we will build upon previous examples and if you missed the last in the series it is available here. Last time we looked at the RX stage in…